Poulan P3314WS User Manual - Page 6
Assembly - p3314wsa parts
View all Poulan P3314WS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
Computed kickback angle (CKA) Table MODEL P3314 / P3314WS P3314WSA P3416 / P3516PR P4018WM / P4018WT P3818AV / P4018AV P4018AV BH BAR P/N Length CHAIN P/N CKA without chain brake 952044368 14″ 952051209 33_ 952044370 16″ 952051211 33_ 952044418 18″ 952051338 33_ NOTE: If this saw is to be used for commercial logging, a chain brake is required and shall not be removed or otherwise disabled to comply with Federal OSHA Regulations for Commercial Logging. WARNING: The engine exhaust from this product contains chemicals known to the State of California to cause cancer, birth defects or other reproductive harm. SAFETY NOTICE: Exposure to vibrations through prolonged use of gasoline powered hand tools could cause blood vessel or nerve damage in the fingers, hands, and joints of people prone to circulation disorders or abnormal swellings. Prolonged use in cold weather has been linked to blood vessel damage in otherwise healthy people. If symptoms occur such as numbness, pain, loss of strength, change in skin color or texture, or loss of feeling in the fingers, hands, or joints, discontinue the use of this tool and seek medical attention. An anti-vibration system does not guarantee the avoidance of these problems. Users who operate power tools on a continual and regular basis must monitor closely their physical condition and the condition of this tool. SPECIAL NOTICE: Your saw is equipped with a temperature limiting muffler and spark arresting screen which meets the requirements of California Codes 4442 and 4443. All U.S. forest land and the states of California, Idaho, Maine, Minnesota, New Jersey, Oregon, and Washington require by law that many internal combustion engines to be equipped with a spark arresting screen. If you operate a chain saw in a state or locale where such regulations exist, you are legally responsible for maintaining the operating condition of these parts. Failure to do so is a violation of the law. Refer to the SERVICE section for maintenance of the spark arresting screen. Failure to follow all Safety Rules and Precautions can result in serious injury. If situations occur which are not covered in this manual, use care and good judgement. If you need assistance, contact your authorized service dealer or call 1-800--554--6723. STANDARDS: This saw is listed by Underwriter's Laboratories, Inc., in accordance with: ANSI B175.1- 2000 American National Standards for Gasoline--Powered Chain Saws -- Safety Requirements CSA Z62.1- 03 Chain Saws -- Occupational Health and Safety CSA Z62.3- 96 Chain Saw Kickback Occupational Health and Safety ASSEMBLY Protective gloves (not provided) should be worn during assembly. ATTACHING THE BAR & CHAIN (If not already attached) WARNING: If received assembled, repeat all steps to ensure your saw is properly assembled and all fasteners are secure. Always wear gloves when handling the chain. The chain is sharp and can cut you even when it is not moving! 1. Loosen and remove the bar nuts and the clutch cover from the saw. 2. Remove the plastic shipping spacer (if present). Clutch cover Bar nuts Chain adjustment tool (Bar Tool) Location of shipping spacer 3. 6 An adjusting pin and screw is used to ad- just the tension of the chain. It is very important when assembling the bar, that the pin located on the adjusting screw aligns into a hole in the bar. Turning the screw will