Poulan PD22PH48STD User Manual - Page 13
To Operate Mower See Fig. 10, To Adjust Gauge Wheels See Fig. 9, To Operate On Hills, To Transport - lawn mowers
View all Poulan PD22PH48STD manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
OPERATION The cutting height range is approximately 1-1/2" to 4". The heights are measured from the ground to the blade tip with the engine not running. These heights are approximate and may vary depending upon soil conditions, height of grass and types of grass being mowed. • The average lawn should be cut to approximately 2-1/2 inches during the cool season and to over 3 inches during hot months. For healthier and better looking lawns, mow often and after moderate growth. • For best cutting performance, grass over 6 inches in height should be mowed twice. Make the first cut relatively high; the second to desired height. • TO STOP MOWER BLADES - disengage attachment clutch control. CAUTION: Do not operate the mower without either the entire grass catcher, on mowers so equipped,or the deflector shield in place. PULL OUT TO "ENGAGE" ATTACHMENT LIFT LEVER HIGH POSITION TO ADJUST GAUGE WHEELS (See Fig. 9) Gauge wheels are properly adjusted when they are slightly off the ground when mower is at the desired cutting height in operating position. Gauge wheels then keep the deck in proper position to help prevent scalping in most terrain conditions. NOTE:Adjust gauge wheels with tractor on a flat level surface. • Adjust mower to desired cutting height (See "TO AD- JUST MOWER CUTTING HEIGHT" in the Operation section of this manual). • Remove retainer spring and clevis pin which secure each gauge wheel bar. • Lower gauge wheels to ground. Raise gauge wheels slightly to align holes in bracket and gauge wheel bar and insert clevis pin. Gauge wheels should be slightly off the ground. • Replace retainer spring into clevis pin. • Be sure all gauge wheels are in the same setting. IMPORTANT:BE SURETO READJUST GAUGEWHEELS IFYOU CHANGE THE CUTTING HEIGHT OF THE MOWER DECK. RETAINER SPRING 01977 ATTACHMENT CLUTCH SWITCH PUSH IN TO "DISENGAGED" LOW POSITION 02142 DEFLECTOR SHIELD FIG. 10 TO OPERATE ON HILLS WARNING: Do not drive up or down hills with slopes greater than 15° and do not drive across any slope. • Choose the slowest speed before starting up or down hills. • Avoid stopping or changing speed on hills. • If stopping is absolutely necessary, push brake pedal quickly to brake position and engage parking brake. CLEVIS PIN • To restart movement, slowly release parking brake and brake pedal. • Slowly depress appropriate drive pedal to slowest setting. FIG. 9 • Make all turns slowly. TO TRANSPORT (See Figs. 7 and 11) TO OPERATE MOWER (See Fig. 10) Your tractor is equipped with an operator presence sensing switch. Any attempt by the operator to leave the seat with the engine running and the attachment clutch engaged will shut off the engine. You must remain fully and centrally positioned in the seat to prevent the engine from hesitating or cutting off when operating your equipment on rough, rolling terrain or hills. When pushing or towing your tractor, be sure to disengage transmission by placing freewheel control in freewheeling position. Free wheel control is located at the rear drawbar of tractor. • Raise attachment lift to highest position with attachment lift control. • Pull freewheel control out and into the slot and release so it is held in the disengaged position. • Select desired height of cut. • Do not push or tow tractor at more than two (2) • Lower mower with attachment lift control. MPH. • Start mower blades by engaging attachment clutch • To reengage transmission, reverse above procedure. control. 13