Poulan PD22PH48STD User Manual - Page 20
Service And Adjustments
View all Poulan PD22PH48STD manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
SERVICE AND ADJUSTMENTS WARNING:TO AVOID SERIOUS INJURY, BEFORE PERFORMING ANY SERVICE OR ADJUSTMENTS: • Depress brake pedal fully and set parking brake. • Place attachment clutch in "DISENGAGED" position. • Turn ignition key to "STOP" and remove key. • Make sure the blades and all moving parts have completely stopped. • Disconnect spark plug wire from spark plug and place wire where it cannot come in contact with plug. TRACTOR TO REMOVE MOWER (See Fig. 18) • Place attachment clutch in "DISENGAGED" position. • If equipped, turn height adjustment knob to lowest setting. • Lower mower to its lowest position. • Disengage belt tension rod from lock bracket. CAUTION: Rod is spring loaded. Have a tight grip on rod and release slowly. • Remove retainer spring holding anti-swaybar to chassis bracket and disengage anti-swaybar from bracket. • Remove four retainer springs from front plate assembly and remove plate. • Remove retainer springs from suspension arms at deck and disengage arms from deck. • Raise attachment lift to its highest position. • Slide mower forward and remove belt from electric clutch pulley. • Slide mower out from under right side of tractor. TO INSTALL MOWER Be sure tractor is on level surface and mower suspension arms are raised with attachment lift control. Engage parking brake. • Swing anti-sway bar to left side of mower deck. • Slide mower under tractor with deflector shield to right side of tractor. IMPORTANT: CHECK BELT FOR PROPER ROUTING IN ALL MOWER PULLEY GROOVES. • If equipped, turn height adjustment knob counter- clockwise until it stops. • Lower mower linkage with attachment lift control. • Be sure belt tension rod is in disengaged position. • Install belt into electric clutch pulley groove. • Place the suspension arms on outward pointing deck pins. Retain with double loop retainer spring with loops up as shown. • Install front plate assembly to tractor suspension brackets and retain with single loop retainer springs as shown. SUSPENSION ARMS BELT TENSION ROD (DISENGAGED POSITION) CHASSIS BRACKET RETAINER SPRING LOCK BRACKET FRONT MOWER BRACKET ELECTRIC CLUTCH PULLEY FRONT PLATE ASSEMBLY SINGLE LOOP RETAINER SPRING DOUBLE LOOP RETAINER SPRING FLANGED PIN USE PLIERS FOR RETAINER SPRINGS LOOP UP ANTI-SWAY BAR SUSPENSION ARMS DOUBLE LOOP RETAINER SPRINGS (Outward pointing deck pins) FIG. 18 20 02565 DEFLECTOR SHIELD