Poulan PD24H42ST User Manual - Page 6
Assembly
View all Poulan PD24H42ST manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
ASSEMBLY Your new tractor has been assembled at the factory with exception of those parts left unassembled for shipping purposes. To ensure safe and proper operation of your tractor all parts and hardware you assemble must be tightened securely. Use the correct tools as necessary to insure proper tightness. TOOLS REQUIRED FOR ASSEMBLY A socket wrench set will make assembly easier. Standard wrench sizes are listed. (2) 9/16" wrench Utility knife (1) 1/2" wrench Tire pressure gauge (1) 3/4" wrench Pliers (1) 3/4" socket with drive ratchet When right or left hand is mentioned in this manual, it means when you are in the operating position (seated behind the steering wheel). TO REMOVE TRACTOR FROM CARTON UNPACK CARTON • Remove all accessible loose parts and parts cartons from carton . • Cut along dotted lines on all four panels of carton. Remove end panels and lay side panels flat. • Check for any additional loose parts or cartons and remove. BEFORE REMOVING TRACTOR FROM SKID ATTACH STEERING WHEEL (See Fig. 1) • Remove locknut and large flat washer from steering shaft. • Position front wheels of the tractor so they are pointing straight forward. • Slide the steering sleeve over the steering shaft. • Position steering wheel so cross bars are horizontal (left to right) and slide onto steering wheel adapter. • Secure steering wheel to steering shaft with locknut and large flat washer previously removed. Tighten securely. • Snap steering wheel insert into center of steering wheel. • Remove protective materials from tractor hood and grill. IMPORTANT: CHECK FOR AND REMOVE ANY STAPLES IN SKID THAT MAY PUNCTURE TIRES WHERE TRACTOR IS TO ROLL OFF SKID. STEERING WHEEL INSERT LOCK NUT LARGE FLAT WASHER STEERING WHEEL STEERING SHAFT STEERING WHEEL ADAPTOR STEERING SLEEVE 02818 FIG. 1 CHECK BATTERY (See Fig. 2) • Lift hood to raised position. • If this battery is put into service after month and year indicated on label (label located between terminals) charge battery for minimum of one hour at 6-10 amps. (See "BATTERY" in MAINTENANCE section of this manual for charging instructions). LABEL 02173 FIG. 2 6