Poulan PR270 Owner Manual - Page 8

MUFFLER GASOLINE FILLER CAP CHOKE CONTROL ON / OFF SWITCH OPERATION POWER CORD PLUG ELECTRIC START BUTTON AUGER CONTROL LEVER DISCHARGE CHUTE CONTROL LEVER DRIVE SPEED CONTROL LEVER DEFLECTOR REMOTE CONTROL LEVER PRIMER SAFETY IGNITION KEY FUEL SHUT-OFF VALVE RECOIL STARTER HANDLE CLEAN-OUT TOOL CHUTE DEFLECTOR DISCHARGE CHUTE NOTE: ITEMS ABOVE ARE SHOWN IN THEIR TYPICAL LOCATION ON THE ENGINE. ACTUAL LOCATION MAY VARY WITH THE ENGINE ON YOUR UNIT. LIGHT TRACTION DRIVE CONTROL LEVER HANDLE KNOB MUFFLER AUGERS SKID PLATE FIG. 8 MEETS A.N.S.I. SAFETY REQUIREMENTS Our snow throwers conform to the standards of the American National Standards Institute. Safety ignition key - must be inserted for the engine to start and run. Remove when snow thrower is not in use. Drive speed control lever - used to select forward or reverse motion and speed of snow thrower. Electric start button - used for starting the engine. Recoil starter handle - used for starting engine. Primer - pumps additional fuel from the carburetor to the cylinder for use when starting a cold engine. Choke Control - used for starting a cold engine. ON / OFF switch - used to STOP the engine. Fuel shut off valve - used for shutting off the fuel flow to the engine. Traction drive control lever - used to engage powerpropelled forward or reverse motion of snow thrower. Auger control lever - used to engage auger motion (throw snow). Discharge chute control lever - used to change the direction the snow is thrown. Deflector remote control lever - used to change the distance the snow is thrown. Skid plate - used to adjust height of scraper bar from the ground. 8