Poulan PR524 User Manual - Page 9
Meets A.n.s.i. Safety Requirements
View all Poulan PR524 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
SAFETY IGNITION KEY SPARK PLUG CHOKE CONTROL THROTTLE / ENGINE CONTROL RECOIL STARTER HANDLE PRIMER NOTE: ITEMS ABOVE ARE SHOWN IN THEIR TYPICAL LOCATION ON THE ENGINE. ACTUAL LOCATION MAY VARY WITH THE ENGINE ON YOUR UNIT. OPERATION ENGINE OIL CAP WITH DIPSTICK AUGER CONTROL LEVER DISCHARGE CHUTE CONTROL LEVER DRIVE SPEED CONTROL LEVER DEFLECTOR REMOTE CONTROL LEVER GASOLINE FILLER CAP CHUTE DEFLECTOR FUEL SHUT-OFF VALVE TRACTION DRIVE CONTROL LEVER DISCHARGE CHUTE OIL DRAIN PLUG CLEAN-OUT TOOL HANDLE KNOB MUFFLER TOOLBOX AUGERS SKID PLATE FIG. 8 MEETS A.N.S.I. SAFETY REQUIREMENTS Our snow throwers conform to the standards of the American National Standards Institute. Toolbox - used to store spare shear bolts, locknuts and wrench. Throttle/engine control - used to select either FAST or SLOW engine speed and to STOP the engine. Safety ignition key - must be inserted for the engine to start and run. Remove when snow thrower is not in use. Traction drive control lever - used to engage power-propelled forward or reverse motion of snow thrower. Recoil starter handle - used for starting the engine. Auger control lever - used to engage auger motion (throw Primer - pumps additional fuel from the carburetor to the snow). cylinder for use when starting a cold engine. Discharge chute control lever - used to change the di- Choke control - used for starting a cold engine. rection the snow is thrown. Deflector remote control lever - used to change the distance the snow is thrown. 9 Skid plate - used to adjust height of scraper bar from the ground.