Poulan PRGT22H50 User Manual - Page 25

SERVICE AND ADJUSTMENTS TERMINAL ACCESS DOOR KEPS NUT HEX BOLT ADJUSTMENT BOLT SPRING BUSHING POSITIVE (RED) CABLE TERMINAL GUARD NEGATIVE (BLACK) CABLE FIG. 32 TO REPLACE HEADLIGHT BULB • Raise hood. • Pull bulb holder out of the hole in the backside of the grill. • Replace bulb in holder and push bulb holder securely back into the hole in the backside of the grill. • Close hood. INTERLOCKS AND RELAYS Loose or damaged wiring may cause your tractor to run poorly, stop running, or prevent it from starting. • Check wiring. See electrical wiring diagram in the Repair Parts section. TO REPLACE FUSE Replace with 30 amp automotive-type plug-in fuse. The fuse holder is located behind the dash. TO ADJUST ATTACHMENT LIFT SPRING (See Fig. 33) • While holding spring bushing with wrench, loosen jam nut. • Turn adjustment bolt clockwise to extend spring and reduce lift effort for heavier attachments. • Turn adjustment bolt counterclockwise for lighter attachments. • Retighten jam nut against spring bushing. IMPORTANT: DO NOT ADJUST FOR MAXIMUM SPRING TENSION WHEN USING LIGHT ATTACHMENTS SUCH AS A MOWER. ADJUST LIFT LEVER SPRING TO AID IN LIFTING ATTACHMENT. DO NOT OVERPOWER SPRING. WHEN REMOVING ATTACHMENT, ALWAYS ADJUST SPRING TENSION TO ITS LOWEST POSITION. ATTACHMENT LIFT SPRING JAM NUT FIG. 33 TO REMOVE HOOD AND GRILL ASSEMBLY (See Fig. 34) • Raise hood. • Unsnap headlight wire connector. • Stand in front of tractor. Grasp hood at sides, tilt toward engine and lift off of tractor. • To replace, reverse above procedures. HOOD HEADLIGHT WIRE CONNECTOR FIG. 34 25