ProForm 10.0 Txp Owners Manual - Page 6
Assembly
View all ProForm 10.0 Txp manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
ASSEMBLY Set the treadmill in a cleared area and remove all packing materials. Be sure that all parts are included before disposing of the packing materials. 1. Insert the Lock Knob (31), with the Lock Knob Washer (30), into the Upright Post (9). Place the Upright Spacer (28) on the end of the Lock Knob. Hold the Spacer in place and raise the Upright Post to a vertical position. Be careful.not to pinch your fingers. Turn the Lock Knob clockwise until it is almost tight. Leave a little play in the Upright Post for the following steps. 9 31 30 0 28 2. Align the upper end of the Side Rail (1) with the left end of the Handrail (10). Turn the Handrail in the direction shown to thread the Handrail into the Side Rail. (Note: If the Handrail will not turn easily, loosen the Handrail Bolt [7] slightly.) Tighten the Handrail and the Handrail Bolt. 3. Align the lower end of the Side Rail (1) -With' the hole in the side of the treadmill Frame (54). Insert the Side Rail Bolt (81) through-the Side Rail and Frame_ Reach under the Frame and tighten the Side Rail Nut (82) onto the end of the Wit: Tighten the Lock Knob (see step 1). Make stire.that all ci rts-are tightened securely before using the.treadmill. 1 1 10 7 1 • 81 .54. j 82 6