ProForm 10.0 Ze Elliptical English Manual - Page 8

4. Apply a generous amount of the included grease to the Upright Axle (48) and to two Small Wave Washers (118). Insert the Upright Axle (48) into the Upright (5) and center it. Slide a Small Wave Washer (118) onto each end of the Upright Axle. Identify the Right and Left Upper Body Legs (6, 7), which are marked with "Right" and "Left" stickers, and orient them as shown. Slide the Right and Left Upper Body Legs (6, 7) onto each side of the Upright Axle (48). Tighten two M8 x 16mm Patch Screws (102) with M8 x 23mm x 2mm Washers (126) into the ends of the Upright Axle (48) at the same time. Firmly tighten the Patch Screws. 4 102 126 7 118 Grease 5 6 118 Grease 48 126 102 5. See the upper drawing. Apply some of the included grease to the axle on the Right Upper 5 Body Leg (6) and to a Medium Wave Washer (119). Slide a Leg Spacer (55) and the Medium Wave Washer (119) onto the Right Upper Body Leg (6). Make sure that the flat side of the Leg Spacer is facing outward. Identify the Right Pedal Arm (12), which is marked with a "Right" sticker, and orient it as shown. Slide the Right Pedal Arm onto the Right Upper Body Leg (6). Attach the Right Pedal Arm (12) with an M8 x 23mm Shoulder Patch Screw (121), an M8 x 16mm x 2mm Washer (120), an Axle Cover (56), and an M8 x 23.5mm x 1mm Washer (110). See the lower drawing. Press the Right Pedal Arm (12) onto the right Adjustment Sleeve (46). Make sure that the Right Pedal Arm latches into place. Tighten an Adjustment Knob (45) onto the right Adjustment Pin (44). Repeat this step on the other side of the elliptical. 8 6 Grease 55 119 110 56 120 12 121 12 46 45 44