ProForm 1080 S Interactive Trainer Elliptical English Manual - Page 5
Assembly
View all ProForm 1080 S Interactive Trainer Elliptical manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
ASSEMBLY Assembly requires two persons. Place all parts of the elliptical crosstrainer in a cleared area and remove the packing materials. Do not dispose of the packing materials until assembly is completed. In addition to the included allen wrenches, assembly requires a phillips screwdriver , an adjustable wrench , and a rubber mallet . Refer to the drawings below to identify the small parts needed for assembly. The number in parentheses below each drawing is the key number of the part, from the PART LIST on page 22. The number following the key number is the quantity needed for assembly. Note: Some small parts may have been pre-assembled. If a part is not found in the parts bag, check to see if it has been pre-assembled. M8 Nylon Locknut (46)-4 M4 x 16mm Screw (66)-12 M8 Split Washer (94)-10 M4 x 16mm Round Head Screw (45)-1 M8.5 Small Washer (53)-2 M4 x 14mm Round Head Screw (93)-2 M10 Washer (99)-2 M4 x 12mm Round Head Screw (18)-2 M6 x 16mm Tapered M8 x 19mm Shoulder Button Screw (107)-8 Screw (22)-2 M8 x 38mm Button Screw (70)-2 M8 x 43mm Button Bolt (50)-4 M8 x 45mm Button Screw (102)-4 M4 x 52mm Screw (98)-2 M8 x 54mm Button Screw (33)-4 M10 x 35mm Carriage Bolt (20)-2 Union Bolt Set (27)-2 1. While another person lifts the front of the Frame (1), thread a Leveling Foot (72) fully into the underside of 1 the Frame. Next, attach the Front Stabilizer (3) to the front of the Frame with two M8 x 54mm Button Screws (33) and two M8 Split Washers (94). 5 3 94 1 94 33 72