ProForm 1080 S Interactive Trainer Elliptical English Manual - Page 9

11. Attach the Left Handlebar Cover (109) to the Console 11 (5) with three M4 x 16mm Screws (66). Attach the Right Handlebar Cover (110) in the same way. 5 See assembly step 9. Tighten the eight M6 x 16mm Tapered Button Screws (107). 110 109 66 12. Plug one end of the Power Supply (115) into the jack at the rear of the elliptical crosstrainer. Plug the other end of the Power Supply into an appropriate outlet that is properly installed in accordance with all local codes and ordinances. 66 12 Note: The Console (5) can be operated with batteries (not included) instead of the Power Supply (96) if desired. To install batteries, follow the instructions below. See the inset drawing. Press the indicated tab on the battery drawer and pull the battery drawer down. Press four "D" batteries into the battery clips; make sure that the batteries are oriented as shown by the markings inside of the battery clips. Then, close the battery drawer. Note: Alkaline batteries are recommended. Battery Drawer Tab Power Jack 96 5 Batteries 13. Make sure that all parts of the elliptical crosstrainer are properly tightened. Note: Some hardware may be left over after assembly is completed. To protect the floor or carpet from damage, place a mat under the elliptical crosstrainer. 9