ProForm 1205 Cst Treadmill English Manual - Page 7

1. Make sure that the power cord is unplugged. 1 With the help of a second person, raise the front of the treadmill and insert the crossbar on the Base (103) into the cutout in the cardboard stand as shown. Have the second person hold the treadmill until assembly step 3 to prevent it from moving forward or backward. WARNING: Serious injury may occur if the treadmill moves forward or backward and falls off the cardboard stand. A second person must hold the treadmill until assembly step 3 to prevent the treadmill from moving, tipping, or falling. 2. Identify the Right Upright (92), which is marked with a "Right" sticker. Have a second person hold the Right Upright (92) near the Right Base Cover (102). See the inset drawing. Tie the wire tie in the lower end of the Right Upright securely around the end of the Upright Wire (93). Then, pull the other end of the wire tie in the top of the Right Upright until the Upright Wire is routed completely through the Right Upright. Gently pull up on the Upright Wire (93) as you set the Right Upright (92) on the Base (103) inside the Right Base Cover (102). Be careful not to pinch the Upright Wire. Attach the Right Upright (92) to the Base (103) with two 3/8" x 3 3/4" Patch Bolts (5) and two 3/8" Star Washers (6). Note: It may be necessary to tip the top of the Right Upright forward slightly as you thread the Patch Bolts into it. Do not tighten the Patch Bolts yet. Attach the Left Upright (91) in the same way. Note: There are no wires on the left side. 2 91 92 93 Wire Tie 103 Wire Tie 93 Cardboard Stand 92 102 103 6 5 7