ProForm 215 Csx Bike English Manual - Page 9

7. Orient the Upright (4) assembly and the Pivot Cover (12) as shown. Slide the Pivot Cover (12) upward to the Handlebar (5). Tip: Bend and flex the Pivot Cover slightly to slide it over the Handlebar. Attach the Pivot Cover (12) to the Handlebar (5) with two M4 x 16mm Screws (90) and two M4 x 22mm Screws (94). Pivot the Handlebar (5) until the hole in the Handlebar is aligned with an adjustment hole in the Upright (4). Tighten an Adjustment Knob (27) into the Handlebar (5) and an adjustment hole in the Upright (4). Make sure that the Adjustment Knob is engaged in one of the adjustment holes. 7 Hole Adjustment Holes 90 27 4 5 94 12 94 90 8. Slide the Front Shield Cover (7) upward onto the Upright (4). 8 While another person holds the Upright (4) near the Frame (1), connect the Extension Wire (59) to the Main Wire (58). Insert the Upright (4) into the Frame (1). Tip: Avoid pinching the wires. Attach the Upright (4) with four M8 x 20mm Screws (74) and four M8 Split Washers (75). Slide the Front Shield Cover (7) downward to the Frame (1) and press it into place. Avoid pinching 4 the wires 7 59 75 1 58 74 75 74 75 9