ProForm 245 Zlx Bike Uk Manual - Page 20

HOW TO ADJUST THE DRIVE BELT If the pedals slip while you are pedaling, even while the resistance is adjusted to the highest level, the drive belt may need to be adjusted. To adjust the drive belt, you must remove the seat post, the post knob, the top shield, the right pedal, and the right shield (see the instructions below). Remove all the screws from the left and right shields; there are two sizes of screws in the shields-note which size of screw you remove from each hole. Then, gently pull the right shield away from the frame. Loosen the M6 x 20mm Hex Screw (46). Then, tighten the M10 x 50mm Hex Screw (33) until the Drive Belt (23) is tight. To remove the Seat Post (5), loosen the Post Knob (11) a few turns, pull the Post Knob outward, and remove the Seat Post. Then, using an adjustable wrench, remove the Post Knob. 23 11 5 9 46 33 When the Drive Belt (23) is tight, tighten the M6 x 20mm Hex Screw (46). 26 Then, reattach the left and right shields, the right pedal, the top shield, the post knob, and the seat post. Using a flat screwdriver, release the tabs along the bottom edge of the Top Shield (9) and slide the Top Shield upward. Then, using an adjustable wrench, turn the Right Pedal (26) counterclockwise and remove it. 20