ProForm 395p Instruction Manual - Page 18

4 Enter a target heart rate setting. If pulse program 9 is selected, the target heart rate setting for the program will begin to flash in the display. If desired, press the Incline buttons to change the target heart rate setting (see EXERCISE INTENSITY on page 29). Note: The same target heart rate setting will be programmed for the entire program. If pulse program 10 is selected, the maximum target heart rate setting of the program will begin to flash in the display. If desired, press the Incline buttons to change the maximum target heart rate setting (see EXERCISE INTENSITY on page 29). Note: If the maximum target heart rate setting is changed, the intensity level of the entire program will change. 5 Press the Start button or the Speed increase button to start the program. A moment after the button is pressed, the treadmill will automatically adjust to the first speed and incline settings of the program. Hold the handrails and begin walking. Pulse program 9 is divided into 100 one-minute segments. The same target heart rate setting is programmed for all segments. (Note: For a shorter workout, simply stop the program before it ends.) Pulse program 10 is divided into 30 one-minute segments. One target heart rate setting is programmed for each segment. Note: The same target heart rate setting may be programmed for two or more consecutive segments. If pulse program 10 is selected, the target Current Segment heart rate setting for the first segment will be shown in the flashing Current Segment col- umn of the matrix. The target heart rate settings for the next four segments will be shown in the columns to the right. When only three seconds re- main in the first segment of the program, both the Current Segment column and the column to the right will flash and a series of tones will sound. When the first segment ends, all target heart rate settings will move one column to the left. The target heart rate setting for the second segment will then be shown in the flashing Current Segment column. During both pulse programs, the console will regularly compare your heart rate to the current target heart rate setting. If your heart rate is too far below or above the target heart rate setting, the speed of the walking belt will automatically increase or decrease to bring your heart rate closer to the target heart rate setting. If the speed of the walking belt reaches 7.5 mph and your heart rate is still too far below the target heart rate setting, the incline of the treadmill will also increase. If the speed or incline setting is too high or too low at any time during the program, you can adjust the setting with the Speed or Incline buttons. However, each time the console compares your heart rate to the target heart rate setting, the speed and/or incline of the treadmill may automatically change to bring your heart rate closer to the target heart rate setting. If your pulse is not detected during the program, the letters "PLS" will flash in the display and the speed and/or incline of the treadmill may automatically decrease. If this occurs, see the instructions included with the optional chest pulse sensor. To stop the program at any time, press the Stop button. The time will begin to flash in the display. To restart the program, press the Start button or the Speed increase button. The walking belt will begin to move at 1 mph. When the console compares your heart rate to the target heart rate setting, the speed and/or incline of the treadmill may automatically change to bring your heart rate closer to the target heart rate setting. 6 Follow your progress with the display. See step 5 on page 14. 7 When you are finished exercising, remove the key from the console. See step 7 on page 15. 18