ProForm 480pi English Manual - Page 6

3. Thread the two included wire ties through the indicated holes in the tube on right side of the Upright (11). Look into the tube right upright (88) and make sure the Wires (21) have been secured to the side shown. Tighten the wire ties and cut off the excess from the ends. 3 11 Ties 11 Tie 21 4. Place the Console Base (46) on the posts on the Upright. Make a loop with the indicated plastic ties and insert the two Wires (21) through the loops. Pull out only enough of the two Wires to connect them to the connectors in the Console Base. Plug the Wires fully into the connectors. Tighten the loops and cut off the excess plastic tie. WARNING: Do not disconnect or connect the Wires while the treadmill power cord is plugged in. Refer to drawing 4b. Thread six Console Screws (88) into the Uprights (11) and the Console Base (46). After all six Console Screws have been started, tighten the Screws until they are snug; do not overtighten the Screws. 4a 46 21 11 4b 11 Ties 21 46 11 5. Attach the Storage Latch (14) to the left Upright (11) with two Small Screws (13). Be careful not to overtighten 5 the Latch Screws. 88 88 88 14 13 11 6. Make sure that all parts are tightened before you use the treadmill. Keep the included allen wrench in a secure place. The allen wrench is used to adjust the walking belt (see page 13). To protect the floor or carpet, place a mat under the treadmill. 6