ProForm 505 Zle Elliptical Uk Manual - Page 21

HOW TO ADJUST THE REED SWITCH If the console does not display correct feedback, the reed switch should be adjusted. To adjust the reed switch, first use a flat screwdriver to rotate the left disc counterclockwise. Then, remove the left disc from the left disc mount. Slide the Reed Switch (38) slightly closer to or away from the Magnet (43). Then, retighten the Reed Switch Screw. Turn the Pulley (19) for a moment. Repeat these actions until the console displays correct feedback. Reattach the left disc by rotating it clockwise into the left disc mount. Next, locate the Reed Switch (38). Turn the Pulley (19) until one of the Magnets (43) on the Pulley is aligned with the Reed Switch. Loosen, but do not remove, the M4 x 16mm Reed Switch Screw (69). 19 HOW TO GREASE THE ROLLERS See the EXPLODED DRAWING near the end of this manual. If the Rollers (51) squeak when moving on the Ramp (3), apply a small amount of white marine grease equally to each Roller. Spread the grease evenly around the Rollers. Pedal the elliptical until a thin film of grease is distributed along the Ramp; then, wipe off any excess grease. 69 43 38 21