ProForm 505 Zle Elliptical Uk Manual - Page 5

ASSEMBLY Assembly requires two persons. Place all parts of the elliptical in a cleared area and remove the packing materials. Do not dispose of the packing materials until assembly is completed. In addition to the included tool(s), assembly requires a Phillips screwdriver wrench , and a rubber mallet . , an adjustable See the drawings below to identify the small parts needed for assembly. The number in parentheses below each drawing is the key number of the part, from the PART LIST near the end of this manual. The number following the key number is the quantity needed for assembly. Note: If a part is not in the hardware kit, check to see if it has been preassembled. To avoid damaging parts, do not use power tools for assembly. M8 Split Washer (83)-13 16mm Wave Washer (54)-2 19mm Wave Washer (66)-4 M10 Washer (95)-2 M8 x 25mm Washer (98)-6 M8 Locknut (102)-4 M10 Locknut (92)-2 M4 x 16mm Screw (104)-10 M8 x 16mm Patch Screw (110)-4 M8 x 19mm Patch Screw (82)-15 M8 x 38mm Bolt (96)-4 M10 x 45mm Patch Screw (99)-4 M8 x 80mm Patch Screw (84)-2 M10 x 60mm Bolt (100)-2 5