ProForm 565 Ekg Elliptical Uk Manual - Page 5

ASSEMBLY Assembly requires two people. Place all parts of the elliptical trainer in a cleared area and remove the packing materials. Do not dispose of the packing materials until assembly is completed. In addition to the included hex key, assembly requires a phillips screwdriver spanners , a rubber mallet , and a pair of pliers , two adjustable . Use the chart below to identify the small parts used in assembly. The number in parenthesis below each part refers to the key number of the part, from the PART LIST on page 22. The number after the dash indicates the quantity needed for assembly. Note: Some parts may have been pre-attached for shipping. If a part is not in the parts bag, check to see if it has been pre-attached. M8 Nylon Locknut (38)-6 M10 Nylon Locknut (33)-6 M10 Split Washer (59)-2 M8.5 Washer (55)-2 M8.5 Large Washer (35)-2 Wave Washer (75)-2 M4 x 16mm Screw (52)-4 M4 x 19mm Flange Screw (36)-6 M4 x 22mm Screw (42)-2 M8 x 25mm Patch Screw (56)-2 M8 x 45mm Button Bolt (50)-4 Pedal Arm Bolt Set (40)-2 M10 x 76mm Button Bolt (27)-2 M10 x 75mm Carriage Bolt (34)-4 5