ProForm 565 Ekg Elliptical Uk Manual - Page 8

7. Apply a generous amount of the included grease to the Pivot Axle (73) and to the two M8.5 Washers (55). 7 Next, insert the Pivot Axle into the Upright (2) and cen- tre it. Reapply grease to both ends of the Pivot Axle. Slide a Handlebar Spacer (47) onto the short tube on each Handlebar (6, 8), and rotate the Handlebar Spacers so the arrows are pointing toward the floor. Next, slide the Handlebars onto the Pivot Axle (73). Make sure that the Handlebars are on the correct sides. Tighten an M8 x 25mm Patch Screw (56) with an M8.5 Washer (55) and a Wave Washer (75) into each end of the Pivot Axle (73). Then, orient the two Handlebar Caps (46) as shown, and press the small tabs on the Handlebar Caps into the two Handlebar Spacers (47). 8 6 Grease 73 46 55 56 75 46 47 Arrow 2 8. Apply a generous amount of grease to the axle on the left Disc Crossbar (16). Slide the Left Pedal Arm (11) onto the axle and attach it with an M8.5 Large Washer (35) and an M8 Nylon Locknut (38). Insert the left Handlebar Arm (5) into the bracket on the end of the Left Pedal Arm (11), and attach it with a Pedal Arm Bolt Set (40). Repeat this step to attach the right Pedal Arm (not shown). See step 6. Tighten the M8 x 45mm Button Bolts (50) in the Handlebar Arms (5). Tighten the two M10 x 76mm Button Bolts (27). 9. Find the Left Pedal (13), which has a ridge on the right side. Attach the Left Pedal to the Left Pedal Arm (11) with three M4 x 19mm Flange Screws (36) as shown. Attach the Right Pedal to the Right Pedal Arm (not shown) in the same way. 8 5 40 40 11 9 11 27 38 35 16 Grease 13 36 10. Make sure that all parts of the elliptical trainer are properly tightened. Place a mat under the elliptical trainer to protect the floor or carpet from damage. 8