ProForm 570 Uk Manual - Page 6

Tighten a Handrail Bolt 74 with a Handrail Washer 75

Get ProForm 570 PDF manuals and user guides View all ProForm 570 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 6 highlights

3. Hold one of the Handrails (1) at an angle as shown and 3 insert the upper end as far as possible into the right Upright (11). Keep the lower end of the Handrail away 1 from the treadmill to avoid scratching the finish. Next, rotate the lower end of the Handrail to the position 1 shown by the dotted line. 11 11 Slide the other Handrail (1) into the left Upright (11) as described above. 3a. With the help of a second person, carefully tip the Uprights (11) down so the Extension Legs (34) are vertical as shown. Tighten a Handrail Bolt (74) with a Handrail Washer (75) into the left Extension Leg (34) and the lower end of the left Handrail (1) as shown. Note: To align the hole in the Handrail with the hole in the Extension Leg, it may be necessary to have a second person stand on the treadmill and lift the Handrail. Next, tighten a Handrail Bolt (74) with a Handrail Washer (75) into the right Extension Leg (34) and the lower end of the right Handrail (1). With the help of a second person, carefully raise the Uprights (11) back to the vertical position. 4. The console requires three 1,5 V batteries (included). Alkaline batteries are recommended. To install batteries, first touch one of the Handrails (1) to discharge any static. Next, open the battery cover as shown. Insert three batteries into the battery compartment, making sure that the negative (-) ends of the batteries are touching the springs in the battery compartment. Close the battery cover, push up on the battery cover tab, and then push the tab forward as shown in the far right drawing. Be sure that the tab locks into place. 5. Attach the Storage Latch (14) to the left Upright (11) with two Latch Screws (101). Be careful not to overtighten the Screws. 6. Make sure that all parts are tightened before you use the treadmill. Keep the included allen wrench in a secure location. The allen wrench is used to adjust the walking belt (see page 13). To protect the floor or carpet, place a mat under the treadmill. 6 3a 34 74 75 34 4 Battery Cover 1 5 11 34 11 1 Batteries Battery Cover Tab 101 14

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
6
5.
Attach the Storage Latch (14) to the left Upright (11)
with two Latch Screws (101).
Be careful not to over-
tighten the Screws.
6.
Make sure that all parts are tightened before you
use the treadmill.
Keep the included allen wrench in a
secure location. The allen wrench is used to adjust the
walking belt (see page 13). To protect the floor or car-
pet, place a mat under the treadmill.
4.
The console requires three 1,5 V batteries
(included).
Alkaline batteries are recommended. To install batteries,
first touch one of the Handrails (1) to discharge any
static.
Next, open the battery cover as shown. Insert
three batteries into the battery compartment,
making
sure that the negative (–) ends of the batteries are
touching the springs in the battery compartment.
Close the battery cover, push up on the battery cover
tab, and then push the tab forward as shown in the far
right drawing. Be sure that the tab locks into place.
101
14
11
3.
Hold one of the Handrails (1) at an angle as shown and
insert the upper end as far as possible into the right
Upright (11). Keep the lower end of the Handrail away
from the treadmill to avoid scratching the finish. Next,
rotate the lower end of the Handrail to the position
shown by the dotted line.
Slide the other Handrail (1) into the left Upright (11) as
described above.
3a.
With the help of a second person, carefully tip the
Uprights (11) down so the Extension Legs (34) are verti-
cal as shown.
Tighten a Handrail Bolt (74) with a Handrail Washer (75)
into the left Extension Leg (34) and the lower end of the
left Handrail (1) as shown. Note: To align the hole in the
Handrail with the hole in the Extension Leg, it may be
necessary to have a second person stand on the tread-
mill and lift the Handrail.
Next, tighten a Handrail Bolt (74) with a Handrail
Washer (75) into the right Extension Leg (34) and the
lower end of the right Handrail (1).
With the help of a second person, carefully raise the
Uprights (11) back to the vertical position.
11
11
34
1
1
3
75
74
1
34
34
11
3a
Battery
Cover
Battery
Cover Tab
Batteries
1
4
5