ProForm 605 Hr Elliptical Uk Manual - Page 5
Slide an M10 Split Washer 70 and a Frame Spacer
View all ProForm 605 Hr Elliptical manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
1. Identify the Front Stabiliser (3), which has Wheels (32) attached to it. Whilst another person lifts the front of the Frame (1), attach the Front Stabiliser to the Frame with two M10 x 112mm Carriage Bolts (34) and two M10 Nylon Locknuts (29). Make sure that the Front Stabiliser is turned so the Wheels are not touching the floor. 2. Whilst another person lifts the back of the Frame (1), attach the Rear Stabiliser (4) to the Frame with two M10 x 112mm Carriage Bolts (34) and two M10 Nylon Locknuts (29). 1 34 32 2 32 3 1 29 29 4 3. Whilst another person holds the Upright (2) in the 3 position shown, connect the Upper Wire Harness (86) to the Lower Wire Harness (87). Carefully pull the upper end of the Upper Wire Harness to remove any slack. Whilst holding the upper end of the Upper Wire Harness, insert the Upright into the Frame (1). Do not pinch the Wire Harnesses. Slide an M10 Split Washer (70) and a Frame Spacer (83) onto the M10 x 90mm Button Screw (63), and insert the Button Screw into the Frame and the Upright. Make sure that the concave end of the Frame Spacer is turned toward the Frame. Do not tighten the Button Screw yet. 29 1 2 34 Make sure the Wire Harnesses (86, 87) do not get pinched and damaged during this step. 4. Connect the wire harness on the Handgrip Pulse Sensor (81) to the indicated wire harness on the Console (5). Insert both wire harnesses into the opening in the bottom of the Console. See the inset drawing. Insert the metal tube on the Handgrip Pulse Sensor (81) into the metal bracket inside the Console (5) as shown. Be careful not to pinch the wire harnesses. Align the holes in the metal tube with the holes in the metal bracket, and tighten two M4 x 16mm Screws (66) into the indicated holes. 5 63 70 83 86 87 1 4 5 81 66 5 Bracket Tube 66 81 Wire Harnesses