ProForm 605 Hr Elliptical Uk Manual - Page 7

8. Identify the Left Pedal (13). Attach the Left Pedal to the left Pedal Spring (14) with an Adjustment Bolt (20), an 8 M10 Washer (38), an M10 Split Washer (70), and a 20 Pedal Knob (15) as shown. Note: The Left Pedal can be attached in several positions using the five positions in the Left Pedal and the three holes in the Pedal Spring. 13 Attach the Right Pedal (not shown) in the same way. Make sure that both Pedals are in the same hole and in the same pedal position. 14 38 70 See step 6. Tighten the M8 x 45mm Button Bolts (50) in the Handlebar Legs (79). See step 3. Tighten the 15 M10 x 90mm Button Screw (63). 9. Make sure that all parts of the elliptical crosstrainer are properly tightened. Note: Some hardware may be left over after assembly is completed. To protect the floor or carpet from damage, place a mat under the elliptical crosstrainer. INSTALLING THE RECEIVER FOR THE OPTIONAL CHEST PULSE SENSOR If you purchase the optional chest pulse sensor (see page 19), follow the steps below to install the receiver and the jumper wire included with the chest pulse sensor. 1. Remove the four indicated screws from the back of the Console (5). Lift off the front of the Console. 1 5 Lift Here Short Screws Long Screws 2. Plug the jumper wire (A) into the indicated jack on the Console (5). Connect the other end of the jumper wire 2 to the wire on the receiver (B). Note: Any other wires included with the chest pulse sensor can be discarded. 5 Next, peel the paper off the adhesive pad on the back of the receiver (B). Orient the receiver as shown, and press it onto the Console (5) in the indicated location. See step 1 above. Reattach the front of the Console (5) with the four screws. Make sure that no wires are pinched. B Cylinder Jack A 7