ProForm 650 English Manual - Page 15
Route the High Cable 73 around a 4 Pulley
View all ProForm 650 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
29. Wrap the High Cable (73) around a 4" Pulley 29 (35). Attach the Pulley and a Cable Trap (44) to the top hole in the Pulley Bracket (91) attached to the Leg Press Cable (76), with a 3/8" x 1 3/4" Bolt (60) and a 3/8" Nylon Jamnut (63). 35 30. Route the High Cable (73) up through the next slot in the Top Frame (1) and wrap the Cable around a 4" Pulley (35) in the direction shown. Attach the 4" Pulley (35) to the Top Frame (1) with a 3/8" x 2 1/2" Bolt (54), two 3/8" Washers (55), two 5/8" x 1/2" Bushings (42), and a 3/8" Nylon Jamnut (63). 44 73 91 63 60 76 30 63 35 73 1 55 42 55 54 31. Route the High Cable (73) around a 4" Pulley (35) and down through the indicated slot in the Top Frame (1). Attach the 4" Pulley (35) to the Top Frame (1) with a 3/8" x 2 1/2" Bolt (54), two 3/8" Washers (55), two 5/8" x 1/2" Bushings (42), and a 3/8" Nylon Jamnut (63). Let the High Cable (73) hang over the weight stack; it will be attached in step 38. 31 35 1 63 55 42 73 55 42 54 32. Locate the Low Cable (72), which has a ball on each end. Route the Low Cable through the slots in the Leg Lever (29) and the Base (8). 32 Attach a 4" Pulley (35) inside the Leg Lever (29) with a 3/8" x 2 1/2" Bolt (54), two 3/8" Washers (55), two 5/8" x 1/2" Bushings (42), and a 3/8" Nylon Jamnut (63). Attach the 1/2" x 1 3/4" Bushing (94) inside the bottom of the Leg Lever (29) with a 5/16" x 2 1/2" Bolt (96), two 5/16" Washers (80), and a 5/16" Nylon Jamnut (79). Press a 2" Square Inner Cap (33) into the bottom of the Leg Lever. Note: It may be easier to attach the 2" Square Inner Cap if you pivot the Leg Lever upward. 15 29 8 42 55 94 63 79 80 33 55 54 42 96 80 35 72