ProForm 675 Cardio Cross Trainer Elliptical English Manual - Page 8

7. Identify the Left Pedal Leg (11), which is marked with a 7 sticker. Attach the Left Pedal (13) to the Left Pedal Leg with two M8 x 52mm Button Screws (27), two M8 Split 13 Washers (28), and two M8 Washers (71). Attach the Right Pedal (not shown) in the same way. 11 71 28 71 28 27 8. Apply a small amount of grease to the axle on the left 8 Disc Crossbar (16). Slide the Left Pedal Leg (11) onto the axle. Apply a small amount of grease to a Large Grease Wave Washer (72) and press it onto the end of the Left Pedal Leg. Slide a Pedal Leg Washer (35) onto an M10 x 27mm Patch Screw (40), and tighten the Patch Screw into the axle. 16 Next, hold the lower end of the left Handlebar Leg (5) inside of the bracket on the front of the Left Pedal Leg (11). Apply grease to an M10 Bolt Set (25). Attach the Handlebar Leg to the Left Pedal Leg with the Bolt Set. Do not overtighten the Bolt Set; the Handlebar Leg must pivot freely. 11 72 40 35 2 5 Attach the Right Pedal Leg (not shown) to the right side of the elliptical crosstrainer in the same way. See step 5. Tighten the M10 x 74mm Button Bolts (7) in the Upright (2). 25 Grease See step 6. Tighten the M8 x 45mm Button Bolts (50) in the Handlebar Legs (5). 25 11 9. Make sure that all parts of the elliptical crosstrainer are properly tightened. Note: Some hardware may be left over after assembly is completed. To protect the floor or carpet from damage, place a mat under the elliptical crosstrainer. 8