ProForm 695e English Manual - Page 7
onto an Axle Screw 30. Tighten the Axle Screw into
View all ProForm 695e manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
6. Slide an M8 Split Washer (58) and an M8 Washer (81) onto an Axle Screw (30). Tighten the Axle Screw into one end of the Incline Axle (29). Next, apply a small amount of the included grease to the Incline Axle. Align the indicated tubes on the Incline Frame (5) with the tubes on the Base (1). Make sure that the Incline Frame is turned so the V-shaped grooves are on top. Insert the Incline Axle (29) through the Incline Frame and the Base. Note: It may be helpful to tap the Incline Axle with a rubber mallet to insert it. Slide an M8 Split Washer (58) and an M8 Washer (81) onto the other Axle Screw (30). Tighten the Axle Screw into the open end of the Incline Axle (29). 7. The Console (87) requires two ÒAAÓ batteries (not included). Alkaline batteries are recommended. To install batteries, turn the console over and insert two batteries into the battery clip as shown in the inset drawing. Make sure that the negative ends of the batteries (marked ÒÑÓ) are touching the springs in the battery clip. Attach a Plastic Tie (53) to the battery clip as shown. Attach the Console (87) to the Console Base (49) with four M4 x 16mm Screws (35), making sure that the indicated wires are extending from the Console Base (49). Be careful not to pinch the wires. 8. Attach the Console Plate (91) to the Upright (2) with four Console Plate Screws (92) and four M10 Split Washers (93). Make sure that the Pulse Wires (86) and the Extension Wire (51) are extending from the Upright (2) through the Console Plate (91). Be careful not to pinch the wires. Push the two Bottle Holders (90) into the Console Plate (91) as shown. 6 1 Grease 81 58 29 30 7 87 49 Wires 8 86 2 93 V-shaped Groove 5 58 81 30 Tubes Tubes Batteries 53 Battery Clip 35 90 91 51 93 92 7