ProForm 8.0 Txp English Manual - Page 6
Assembly, Operation, Adjustment
View all ProForm 8.0 Txp manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
ASSEMBLY Set the treadmill in a cleared area and remove all packing materials. Be sure that all parts are Included before disposing of the packing materials. 1. Insert the Lock Knob (31), with the Lock Knob Washer (30), into the Upright Post (9). Place the Upright Spacer (27) on the end of the Lock Knob. Hold the Spacer in place and raise the Upright Post to a vertical position. Be careful not to pinch your fingers. Turn the Lock Knob clockwise until it is almost tight. Leave a little play in the Upright Post for the following steps. 9 31 30 27 2. Align the upper end of the Side Rail (1) with the left end of the Handrail (10). Turn the Handrail in the direction shown to thread the Handrail into the Side Rail. (Note: If the Handrail will not turn easily, loosen the Handrail Bolt [7] slightly.) Tighten the Handrail and the Handrail Bolt 3. Align the lower end of the Side Rail (1) with the hole in the side of the treadmill Frame (54). Insert the Side Rail Bolt (80) through the Side Rail and Frame. Reach under the Frame and tighten the Side Rail Nut (81) onto the end of the Bolt. Tighten the Lock Knob (see step 1). Make sure that all parts are tightened securely before using the treadmill. 1 10 7 80 54 I 81 OPERATION AND ADJUSTMENT MAINTENANCE-FREE WALKING PLATFORM This treadmill features a walking platfonii with a specially designed hydrocarbon slip agent. Do not apply silicone spray or any other substance.to the walking platform or the walking belt. Such substances wilt:deteriorate the-surfacebt-the platform and cause excessive wear. The walking platform has an initial break-in period of 5 to 10 minutes. During this period there may be a normal 6 drop in speed.