ProForm 900 Cardiocross Trainer English Manual - Page 5

ASSEMBLY Assembly requires two persons. Place all parts of the elliptical crosstrainer in a cleared area and remove the packing materials. Do not dispose of the packing materials until assembly is completed. In addition to the included allen wrenches, assembly requires a phillips screwdriver , an adjustable wrench , and a rubber mallet . As you assemble the elliptical crosstrainer, use the drawings below to identify the small parts used in assembly. The number in parenthesis below each drawing refers to the key number of the part, from the PART LIST on page 22. The second number refers to the quantity used in assembly. Note: Some small parts may have been pre-assembled for shipping. If a part is not in the parts bag, check to see if it has been pre-assembled. M8 Nylon M10 Nylon M10 Split M8 Wave Washer Locknut (38)-4 Locknut (33)-4 Washer (59)-8 Washer (55)-2 (84)-2 M10 Washer (78)-2 M4 x 16mm Screw (52)-2 M6 x 25mm Screw (7)-1 M8 x 25mm Patch Screw (56)-2 M10 x 29mm Pedal Bolt (80)-2 Spring Bracket Washer (35)-2 M8 x 45mm Button Screw (50)-4 M10 Bolt Set (74)-2 M10 x 27mm Patch Screw (40)-2 M10 x 27mm Button Screw (67)-6 M10 x 75mm Carriage Bolt (34)-4 1. Identify the Front Stabilizer (10), which has Wheels (22) 1 attached to it. While another person lifts the front of the Frame (1), attach the Front Stabilizer to the Frame with two M10 x 75mm Carriage Bolts (34) and two M10 Nylon Locknuts (33). Make sure that the Front 22 34 Stabilizer is turned so the Wheels are not touching the floor. 34 22 10 1 33 5