ProForm 920s Ekg Bike Canadian English Manual - Page 5

1. Identify the Front Stabilizer (2), which has Wheels (30) on the ends. While another person lifts the front of the 1 30 Frame (1) slightly, attach the Front Stabilizer to the 65 Frame with two M10 x 112mm Carriage Bolts (65) and two M10 Black Nylon Locknuts (63). Make sure that the Front Stabilizer is turned so the Wheels are not 30 touching the floor. 2 1 63 2. While another person lifts the back of the Frame (1) slightly, attach the Rear Stabilizer (3) to the Frame with two M10 x 112mm Carriage Bolts (65) and two M10 Black Nylon Locknuts (63). 2 63 63 3 1 3. While another person holds the Upright (13) in the position shown, connect the Upper Wire Harness (36) to the Lower Wire Harness (35). Carefully pull the upper end of the Upper Wire Harness to remove any slack from the Wire Harnesses; make sure that the connectors do not catch on the indicated rod. Turn the indicated Adjustment Knob (28) counterclockwise two or three turns to loosen it. Next, pull the Knob, insert the Upright (13) into the Frame (1), and then release the Knob. Be careful to avoid pinching the Wire Harnesses (35, 36). Move the Upright up and down slightly until the pin on the Knob snaps into one of the holes in the Upright. Then, turn the Knob clockwise until it is tight. Tighten the M6 x 25.4mm Button Screw (33) into the Frame (1) and into the slot in the side of the Upright (13). 4. The Console (16) requires four 1,5 V (D) batteries (not included); alkaline batteries are recommended. Press the tab on the battery cover, and lift off the battery cover. Insert four batteries into the battery compartment. Make sure that the batteries are oriented as shown by the markings inside the battery compartment. Reattach the battery cover. 65 3 Slot 36 35 13 Rod Be careful to avoid pinching the Wire Harnesses. 1 28 33 4 Tab Battery Cover Batteries 16 5