ProForm 920s Ekg Bike Canadian English Manual - Page 8
INSTALLING THE RECEIVER FOR THE OPTIONAL CHEST PULSE SENSOR, sure that no wires are pinched.
View all ProForm 920s Ekg Bike manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
INSTALLING THE RECEIVER FOR THE OPTIONAL CHEST PULSE SENSOR If you purchase the optional chest pulse sensor (refer to page 18), follow the steps below to install the receiver and the short jumper wire included with the chest pulse sensor. 1. Remove the two short screws and the two long screws from the back of the Console (16). Lift off the front of the Console. 1 16 Lift Here Short Screws Long Screws 2. Plug the short jumper wire (A) into the indicated jack on the Console (16). Connect the other end of the short 2 jumper wire to the wire on the receiver (B). Note: Any other wires included with the chest pulse sensor can be 16 discarded. Next, peel the paper off the adhesive pad on the back of the receiver (B). Orient the receiver as shown, and press it onto the Console (16) in the indicated location. Refer to step 1 above. Reattach the front of the Console (16) with the short and long screws. Make sure that no wires are pinched. B Cylinder Jack A 8