ProForm Crosswalk1.50 Hp Owners Manual - Page 5

OPERATION AND ADJUSTMENT For your convenience, the CROSS WALK is delivered completely assembled in the compact stowaway position. Set the CROSS WALK in a 10 cleared area and remove all packing materials. Make sure that all parts are included before disposing of the pocking materials. To convert the CROSS WALK to the operating position, first slide the Lock Knob Washer (78) onto the Lock Knob (77). Raise the Upright (10) to the 78 vertical position and tighten the Lock Knob into the Upright. APPLYING SILICONE LUBRICANT To reduce the friction of the walking belt and minimize wear, a non-oil-, non-petroleum-base silicone lubricant must be applied to the walking platform before the CROSS WALK is used. WITH THE POWER CORD UNPLUGGED, lift each side of the walking belt and spray lubricant generously onto the indicated area. Reapply lubricant after every ten hours of use, or whenever performance decreases. Lubricant is available at hardware and automotive stores. Uni•SportTm spray is recommended. PLUGGING THE POWER CORD IN This product must be grounded. If it should malfunction or break down, grounding provides a path of least resistance for electric current to reduce the risk of electric shock. This product is equipped with a cord having an equipmentgrounding conductor and a grounding plug. Plug the power cord into an appropriate outlet that is properly installed and grounded in accordance with all local codes and ordinances. A DANGER: Improper connection of the equipment-grounding conductor can result in a risk of electric shock. Check with a qualified electrician or serviceman if you are in doubt as to whether the product is properly grounded. Do not modify the plug provided with the product-if it will not fit the outlet, have a proper outlet installed by a qualified electrician. This product is for use on a nominal 120-volt circuit, and has a grounding plug as shown in Drawing 1. A temporary adapter like the adapter shown in Drawing 2 may be used to connect this plug too 2-pole receptacle as shown in Drawing 2 if a properly grounded outlet is not available. The temporary adapter should be used only until a properly grounded outlet (Drawing 1) can be installed by a qualified electrician. The green-colored ear, lug, or the like extending from the adapter must be connected to a permanent ground such as a properly grounded outlet box cover. Whenever the adapter is used, it must be held in place by a metal screw. Some 2-pole receptacle outlet box covers are not grounded. Contact a qualified electrician to determine if the outlet box cover is grounded before using an adapter. 1 Grounded Outlet Box 2 oo° 0 0 Grounding Plug. Grounded Outlet Box Adopter Grounding Pin 0; • Grounding Plug Grounding Pin lug Grounded Outlet . Metal Screw 5