ProForm Endurance S7 Uk Manual - Page 24

MAINTENANCE AND TROUBLESHOOTING MAINTENANCE SYMPTOM: The power turns off during use Regularly clean the treadmill and keep the walking belt clean and dry. First, press the power switch into the off position and unplug the power cord. Wipe exterior parts of the treadmill with a damp cloth and a small amount of mild soap. IMPORTANT: Do not spray liquids directly onto the treadmill. To avoid damage to the console, keep liquids away from the console. Then, thoroughly dry the treadmill with a soft towel. TROUBLESHOOTING Most treadmill problems can be solved by following the simple steps below. Find the symptom that applies, and follow the steps listed. If further assistance is needed, see the front cover of this manual. a. Check the power switch (see the drawing c at the left). If the switch has tripped, wait for five minutes and then press the switch back in. b. Make sure that the power cord is plugged in. If the power cord is plugged in, unplug it, wait for five minutes, and then plug it back in. c. Remove the key from the console, and then reinsert it. d. If the treadmill still will not run, please see the front cover of this manual. SYMPTOM: The displays of the console do not function properly SYMPTOM: The power does not turn on a. Make sure that the power cord is plugged into a properly earthed outlet (see page 16). If an extention cord is needed, use only a 3-conductor, 14-gauge (1 mm2) cord that is no longer than 5 ft. (1.5 m). b. After the power cord has been plugged in, make sure that the key is inserted into the console. a. Remove the key from the console and UNPLUG THE POWER CORD. Next, remove the five #8 x 3/4" Screws (4), and carefully pivot off the Motor Hood (65). a 65 4 4 4 c. Check the power switch located on the treadmill frame near the power cord. If the switch protrudes 4 as shown, the switch has tripped. To reset the power switch, wait for five minutes and then press the switch back in. c Tripped Reset 24