ProForm Performance 1050 Treadmill English Manual - Page 7
Assembly - treadmill parts
View all ProForm Performance 1050 Treadmill manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
ASSEMBLY • Assembly requires two persons. • Place all parts in a cleared area and remove the packing materials. Do not dispose of the packing materials until you finish all assembly steps. • After shipping, there may be an oily substance on the exterior of the treadmill. This is normal. If there is an oily substance on the treadmill, wipe it off with a soft cloth and a mild, non-abrasive cleaner. • Left parts are marked "L" or "Left" and right parts are marked "R" or "Right." • To identify small parts, see page 6. • Assembly requires the following tools: the included hex key one adjustable wrench one Phillips screwdriver needlenose pliers scissors To avoid damaging parts, do not use power tools. 1. Go to www.iconsupport.eu on your computer and register your product. 1 • activates your warranty • saves you time if you ever need to contact Customer Service • allows us to notify you of upgrades and offers Note: If you do not have Internet access, call Customer Service (see the front cover of this manual) to register your product. 2. Make sure that the power cord is unplugged. Locate the Upright Wire (70) bundled around the front of the Base (80). Cut the plastic tie securing the Upright Wire. Then, route the Upright Wire into the Base and out of the indicated hole. Press a Base Cap (77) into each side of the Base (80). See the inset drawing. Cut the plastic tie near the Upright Wire (70). Be careful not to damage the Upright Wire. 2 80 Cut 77 70 Hole Tie Cut 70 7