ProForm Performance 750 Treadmill Uk Manual - Page 7

ASSEMBLY •• Assembly requires two persons. •• To identify small parts, see page 6. •• Place all parts in a cleared area and remove the packing materials. Do not dispose of the packing materials until you nish all assembly steps. •• Assembly requires the following tools: the included hex keys •• After shipping, there may be an oily substance on the exterior of the treadmill. This is normal. If there is an oily substance on the treadmill, wipe it off with a soft cloth and a mild, non-abrasive cleaner. •• Left parts are marked “"L”" or “"Left”" and right parts are marked “"R”" or “"Right.”" one adjustable wrench one Phillips screwdriver scissors needlenose pliers To avoid damaging parts, do not use power tools. 1. Go to www.iconsupport.eu on your computer and register your product. 1 •• activates your warranty •• saves you time if you ever need to contact Customer Service •• allows us to notify you of upgrades and offers Note: If you do not have Internet access, call Customer Service (see the front cover of this manual) and register your product. 2. Make sure that the power cord is unplugged. Locate the Upright Wire (77) bundled around the front of the Base (86). Cut the plastic tie securing the Upright Wire. Then, route the Upright Wire out of the indicated hole. Press a Base Cap (81) into each side of the Base (86). See the inset drawing. Cut the plastic tie near the Upright Wire (77). Be careful not to damage the Upright Wire. 2 86 Cut 81 7 Hole 77 Tie Cut 77