ProForm Ramp Trainer 420 Elliptical English Manual - Page 10

9. The Console (10) can be operated with four "D" batteries (not included); alkaline batteries are recommended. IMPORTANT: If the elliptical exerciser has been exposed to cold temperatures, allow it to warm to room temperature before inserting batteries into the Console. If you do not do this, the console displays or other electronic components may become damaged. Remove the battery cover from the bottom of the Console and insert four batteries into the battery compartment. Make sure the batteries are oriented as shown by the diagram inside the battery compartment. Then, reattach the battery cover. The Console (10) can also be operated with an optional power supply (not included). To purchase a power supply, see the front cover of this manual. To avoid damaging the console, use only a manufacturer-supplied power supply. Plug one end of the power supply into the jack on the Console; plug the other end into an outlet installed in accordance with all local codes and ordinances. Have a second person hold the Console (10) near the Upright (2) as shown. Connect the console wires to the Upper Wire Harness (18) and the Pulse Wire (11). Attach the Console (10) to the Upright (2) with four M4 x 16mm Round Head Screws (72). Be careful to avoid pinching the wires. 10. Identify the Left Upper Body Arm (4), which is marked with a "Left" sticker. Orient the Left Upper Body Arm so that the indicated tube is facing inward. Lubricate the upper end of the left Upper Body Leg (6) using a small amount of the included high-temperature lubricant. Then, slide the Left Upper Body Arm (4) onto the Upper Body Leg. Apply a generous amount of grease to the Pivot Axle (16). Then, insert the Pivot Axle through the Left Upper Body Arm (4), an Upper Body Arm Spacer (29), and the Upright (2). Make sure the Upper Body Arm Spacer is oriented as shown, with the arrow pointed down. 9 10 11 72 Console Wires 18 2 10 4 2 Grease 16 29 Tube Arrow Lubricate 6 10