ProForm Smart Strider 495 Cse Instruction Manual - Page 5

ASSEMBLY • Assembly requires two persons. • Place all parts in a cleared area and remove the packing materials. Do not dispose of the packing materials until you finish all assembly steps. • In addition to the included tool(s), assembly requires the following tool(s): one Phillips screwdriver Assembly may be easier if you have a set of wrenches. To avoid damaging parts, do not use power tools. 1. To register your product and activate your warranty in the UK, go to iconsupport.eu. If 1 you do not have internet access, call Customer Service (see the front cover of this manual).  To register your product and activate your warranty in Australia, email or post the following information to the email address or postal address on the front cover of this manual. • your receipt (make sure to keep a copy) • your name, address, and telephone number • the model number, serial number, and name of your product (see the front cover of this manual) 2. If necessary, remove and discard the shipping supports and the shipping screws attached to 2 the rear of the Frame (1). With the help of another person, place some packing inserts from the packing material under the rear of the Frame (1) so that the Frame is lifted off the floor. Have another person hold the elliptical to prevent it from moving from side to side until this step is completed. Orient the Rear Stabilizer (70) as shown. Attach the Rear Stabilizer to the Frame (1) with two M10 x 120mm Screws (84). 70 Then, remove the packing inserts and lower the Rear Stabilizer (70). 1 84 5