ProForm Strideselect 825 Elliptical English Manual - Page 13

4. Monitor your progress with the display. The upper half of the display will show the elapsed time, the distance (total revolutions) you have pedaled, and the resistance level of the pedals. The display will change from one mode to the next every few seconds. Note: When a program is selected (except for pulse program 2), the display will show the time remaining in the program instead of the elapsed time. For the most accurate heart rate reading, continue to hold the handgrip pulse sensor for about 30 seconds. Note: If you continue to hold the handgrip pulse sensor, the display will show your heart rate for about 30 seconds. The display will then show your heart rate along with the other modes. If your heart rate is not shown, make sure that your hands are positioned as described. Avoid moving your hands excessively or squeezing the metal contacts too tightly. For optimal performance, periodically clean the metal contacts using a soft cloth; never use alcohol, abrasives, or chemicals. The lower half of the display will show your pedaling speed (revolutions per minute [RPM]) and the approximate number of calories you have burned. The display will change from one mode to the other every few seconds. The lower half of the display will also show your heart rate when you use the handgrip pulse sensor (see step 5). 5. Measure your heart rate if desired. 6. Turn on the fan if desired. To turn on the fan at low speed, press the fan button. To turn on the fan at high speed, press the fan button a second time. To turn off the fan, press the fan button a third time. Note: If the fan is turned on but the pedals are not moved for thirty seconds, the fan will automatically turn off to conserve the batteries. Rotate the thumb tab on the right side of the fan to adjust the angle of the fan. Thumb Tab If there are sheets of clear plastic on Contacts the metal contacts on the handgrip pulse sensor, remove the plastic. Next, hold the hand- grip pulse sensor with your palms resting on the contacts. When your pulse is detect- ed, the heart-shaped indicator in the lower half of the display will flash each time your heart beats, and your heart rate will be shown. 7. When you are finished exercising, the console will automatically turn off. If the pedals are not moved for a few seconds, the time will begin to flash and the console will pause. If the pedals are not moved for a few minutes, the console will turn off and the display will be reset. 13