ProForm Strideselect 825 Elliptical English Manual - Page 8

5. The Console (5) requires four D batteries (not 5 included); alkaline batteries are recommended. IMPORTANT: If the elliptical exerciser has been exposed to cold temperatures, allow it to warm to room temperature before inserting batteries into the Console. If you do not do this, the con- sole displays or other electronic components may become damaged. Press the tab on the bat- tery door and remove the battery door. Insert four batteries into the Console as shown. Make sure that the batteries are oriented as shown by the markings on the battery door. Reattach the bat- tery door. 5 Batteries Batteries Battery Cover 6. While another person holds the Console (5) near the Upright (2), connect the wire harness on the Console to the Upper Wire Harness (86). Insert the excess wire harness down into the Upright. Next, attach the Console to the Upright with four M4 x 16mm Screws (66). Be careful to avoid pinching the wire harnesses. 6 5 86 66 Wire Harness 66 2 Avoid pinching the wire harnesses during this step 7. Slide the Right Crank Arm (38) onto the four indicated welded bolts; make sure that the Right Crank Arm is in the indicated cutout in the Pedal Disk (8). Next, finger tighten four M8 Jamnuts (80) onto the welded bolts. Then, fully tighten one of the Jamnuts, and then tighten the Jamnut farthest from the first Jamnut. Then, tighten the remaining two Jamnuts. Attach a Hub Cover (48) to the Right Crank Arm (38) with four Cover Screws (82). Then, tighten an Adjustment Knob (45) onto the right Adjustment Pin (17). 7 Welded Bolts Cutout 80 48 8 38 80 82 17 45 8