ProForm Style 8500 Treadmill Uk Manual - Page 9

8. Set the console assembly on the Crossbar (20). Be careful to avoid pinching any of the wires. Make sure that the ground wire (see step 6) and the console wire harness (see step 7) are inside the indicated channel. Hand tighten five 3/4" Screws (2) into the Crossbar (20) and the console assembly. Start all five Screws, but do not tighten them yet. Do not put Screws into the two indicated holes. 8 Channel Console Assembly 2 20 2 2 No Screws 9. Hand tighten four additional 3/4" Screws (2) into the console assembly. Then, tighten all nine 9 Screws used in step 8 and this step; do not overtighten the Screws. Console Assembly 2 2 10. Attach the Latch Housing (73) to the left Upright 10 (84) with two 3/4" Screw (2). Make sure that the large hole in the Latch Housing is on the side shown. Do not overtighten the Screws. If the pin is not preassembled in the Latch Housing (73), remove the knob from the pin. Make sure that the collar and the spring are on the pin as shown. Insert the pin into the Latch Housing, and tighten the knob back onto the pin. Plug in the power cord as described on page 11, and turn on the power as described on page 13. Note: The treadmill may automatically rise to the maximum incline level and then return to the minimum level. 73 Knob 2 Large Hole 84 Spring Pin Collar 9