ProForm Xp 70 Bike Exerciser English Manual - Page 7
Note: The Nylon Locknuts and M8 Split Washers are
View all ProForm Xp 70 Bike Exerciser manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
5. The Console (4) requires four 1.5V "D" batteries (not 5 included); alkaline batteries are recommended. Remove the two battery covers from the Console. Battery Covers Next, insert four batteries into the battery compartments. Make sure that the batteries are oriented as shown by the diagrams inside of the battery com- 13 60 partments. Then, reattach the battery covers to the Console. Attach the Book Holder (13) to the Console (4) with Batteries two M4 x 12mm Screws (60) as shown. 4 6. While another person holds the Console (4) in the position shown, connect the wire harness on the Console to the Upper Wire Harness (42). Insert the excess wire harness down into the Upright (2). Attach the Console (4) to the Upright (2) with four M4 x 16mm Screws (57) and two Console Brackets (70). Be careful to avoid pinching the wire harnesses. 6 70 57 7. Remove the packing tube from the Frame (1). Turn the 7 Seat Knob (20) counterclockwise two or three turns to loosen it. Next, pull the Seat Knob and insert the Seat Post (8) into the Frame. Release the Knob, and move the Seat Post up and down slightly until the pin on the Knob snaps into one of the holes in the Seat Post. Then, turn the Knob clockwise until it is tight. Attach the Seat (9) to the Seat Post (8) with four M8 Nylon Locknuts (65) and four M8 Split Washers (50). Note: The Nylon Locknuts and M8 Split Washers are preattached to the Seat. 57 70 4 42 Wire 2 Harness 9 8 20 1 50 65 Packing Tube 7