ProForm Zx2 Bike English Manual - Page 7
Tip: Avoid pinching the Extension Wire 59.
View all ProForm Zx2 Bike manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
5. Apply some of the included grease to an M6 x 70mm Bolt Set (50). Orient the Handlebar (5) and the Upright (4) as shown. While a second person holds the Handlebar (5) near the Upright (4), insert the Extension Wire (59) upward through the Handlebar. Tip: Avoid pinching the Extension Wire (59). Attach the Handlebar (5) to the Upright (4) with the M6 x 70mm Bolt Set (50) and two M8 Washers (43). Then, attach an M6 x 60mm Bolt Set (51) through the lower bracket on the Handlebar (5). 5 50 5 59 43 Grease 51 43 50 51 4 Avoid pinching the Extension Wire (59) 6. The Console (13) can use four D batteries (not included); alkaline batteries are recommended. 6 IMPORTANT: If the Console has been exposed to cold temperatures, allow it to warm to room temperature before inserting batteries. Otherwise, you may damage the console displays or other electronic compo- nents. Remove the indicated screw, remove the battery cover, and insert the batteries into the battery compartment. Make sure to orient the batteries as shown by the diagrams inside the battery compartment. Then, reattach the battery cover. To purchase an optional power adapter, call the telephone number on the front cover of this manual. To avoid damaging the console, use only a manufacturer-supplied power adapter. Plug one end of the power adapter into the jack on the console; plug the other end into an outlet installed in accordance with all local codes and ordinances. Screw Battery Cover Batteries 13 Batteries 7