Pyle GDV785BK User Guide - Page 5

Flat Base Mounting Install the camera bracket into flat base pedestal, stick flat base pedestal with 3M pads and then attach to the surface of sliding plate or sledge, etc. (Shown below). SideͲHelmet Mounting Mount goggle belt to curve helmet pedestal, then tie the belt around the helmet, adjust curve helmet pedestal to the right position, then fix it firmly onto the helmet using 3M sponge rubber pads, install the camera bracket into curve helmet pedestal (Shown below). TopͲHelmet Mounting Thread the nylon velcro strap into curve helmet pedestal, then thread the nylon velcro strap into helmet and fasten it. Make sure it is fixed firmly (Shown below). Handlebar Mounting Completely loosen the screws on the handlebar mount, apply the protective rubber pads around the handlebar then apply the handlebar mount over the pads. Tighten the screws onto the handlebar grip. Works for standard bicycle diameters. SD Memory Card Access 1) Open the camera back cover 2) Insert the card according to the right direction 3) Close the back cover Removing the SD Card 1) Turn off the camera power and open the back cover. 2) Press the end of the storage card slightly, it will eject automatically. 3) Close the back cover Note: Carefully insert the SD card in the proper direction. Reversed insertion may cause damage to the camera and the SD card. Battery Charging Connect the USB port of charger with the USB port of camera, and then plug in the power. During charging, the red indicator is flicking, when fully charged, the indicator stays on all the time. Note: In order to improve the charging efficiency, please charge the camera while powered off. Please make sure the AC power is present when the charger is plugged in. (FBS
1SP
3ZEFS
4.