Pyle NCHUB35 Instruction Manual - Page 4

2. Plug in the Power Cord to start boiling Start Boiling Boiling Finished 2. Push Button Dispensing: Press "DISPENSE" button to dispense hot water into cup. Cup Touch Dispensing: Holding cup up to touch the cup switch behind the spout to dispense hot water into cup. Boiling indicator is ON Boiling indicator is OFF; Temp indicator is ON 1. Connect Power Cord to Hot Water Dispenser. 2. Plug Power Cord to the power outlet. After connect to the outlet, the"BOILING" indicator lights up and water starts to boil automatically till reaching boiling temperature of (212°F). 3. When Water is boiling, the Hot Water Dispenser will switch in to keep warm mode. The Defaul (or customer select) Temp idicator of 185°F lights up. • Hot Water Dispenser will re-boil again if the water temperature drops below the set temperature level. • If Hot Water Dispenser do not boil automatically, press "RE-BOIL" button to boil water. 4. Each time the"TEMP SET" button is pressed, the keep warm temperature indicator will switch by following sequence; 185°F -> 208°F-> 149°F -> 185°F -> 3. TWO WAYS TO DISPENSE HOT WATER 1. Press "UNLOCK" button, the unlock light is on. (Hot Water Dispenser will auto lock if idle for 10 seconds.) Idle for 10 seconds NOTE: After water has boiled without dispensing for a period. Some air might become trapped in the water pump to prevent pumping water. Simply open then close the lid to solve this issue. 4. STAND-BY FUNCTION 1. During water boiling, press "RE-BOIL" button once, kettle will turn into STANDBY mode and stop boiling. To resume boiling press "RE-BOIL" again. PUSH UNLOCK indicator is ON UNLOCK indicator is OFF 6 www.NutrichefKitchen.com PUSH www.NutrichefKitchen.com 7