Pyle NCHUB35 Instruction Manual - Page 5

2. If Dispenser is in keep warm mode, press "RE-BOIL" button twice to set Hot Water Dispenser into STANDBY mode. Resume boiling by pressing "RE-BOIL"again. PUSH PUSH AGAIN MAINTENANCE BODY Wipe the Hot Water Dispenser body with soft dry cloth. • Wipe with dump cloth, if the stain is hard to remove. (never use soaked cloth!) • Don't use thinner to clean, it might crack the plastic casing. • Any cloth containing chemicals might cause color changing of body. WARNING: This Hot Water Dispenser is not Dishwasher safe! REMOVE SCALE DEPOSIT If using tap water, the minerals in the water will deposit on the surface of stainless steel lining over time. This deposit scale will shorten the life of this Hot Water Dispenser. Please clean this Hot Water Dispenser with citric acid at least once a month. Please follow the instruction on the citric acid's package to clean and remove mineral deposits. LINING Wipe lining with dump sponge. Don't use detergent or any kind of abrasive brush. REPLACE SILICON SEAL The silicon seal may become damaged after a long period of use. It should be replaced. Call our service line or order on our web store for replacement silicon ring. 8 www.NutrichefKitchen.com It is easy to replace silicon ring by removing four screws inside bottom of upper lid and then removing the stainless steel plate. Remove the silicon ring and replace with new ring. Put back Stainless Steel plate and tighten four stainless steel screws. Push down the LID LOCK then hold and pull the LID LOCK up Hold on the Hot Water Dispenser body then pull the lid out of the Hinge. Put the lid back to the Hinge. STORAGE 1. Pull the plug out of outlet. 2. Pull the cord out of kettle. 3. Remove upper lid. 4. Pour all water out of kettle. www.NutrichefKitchen.com 9