Pyle PBC5200BK Instruction Manual - Page 3

2. Introduction of panel USB port: Connect the network card, mass storage device, or charge the phone DC charging interface Charging Indicator RJ45 network cable port Power Switch R: Power C: Charging 0: Off Battery indicator button Battery indicator Restore factory settings 2.1 Description of hardware interfaces Hardware Interface Identity Detailed Description of Functions R Turn on the power switch to R to start the router function Power switch C Charging, switch to C to activate the mobile power bank function to charge devices through the USB port Off switch Battery indicator button USB interface Press this button, the battery indicator will show the current battery, battery indicator is divided into four levels. This interface can connect 3G USB modems, U disk, USB mobile hard disk, flash drive, or connect smart phones, tablet PCs, PSP and other digital terminals for charging. DC charging interface DC 5V input, you can charge the unit through the Micro USB charging cable. Charging indicator RJ45 network port Restore factory settings When the unit is being charged, the indicator is always on WAN port: In the mode of Dynamic IP/Static IP/PPPoE, the port is used as a WAN port to connect a wired network, LAN broadband, xDSL Modem/Cable Modem of hotels. In Routing state, long press for 5 seconds, then release the key, the router will restore to factory settings. -2-