Pyle PHSI50B PHSI50B Manual 1 - Page 9

4. How to play iPod using one key control system i). Press the knob to enter the first-level sub-page (control panel). ii). Choose "iPod Control Menu", you can press knob to enter second-level sub-page (see the picture on Page 4). iii). Rotate the knob to the desired function mode, then press the knob again to enter to the third-level sub- page. When you choose the ( ) function, it has 2 functions: firstly, rotate knob left or right once( to the left is scroll up, to the right is scroll down). Secondly, press the ( ) function once, it has the same function as "OK/Menu" key on remote control. For all other iPod functions please refer to page 6, iPod Control Area. iv). If you want to choose other functions, please refer to step (2) b. above. 5. How to set "ALARM, TIME" using one key control system i). Press the knob to enter the first-level sub-page (control panel). ii). Choose "Time and Alarm Control Menu", you can press knob to enter second-level sub-Page (see the picture on Page 4). iii). Rotate the knob to the desired function mode, then press the knob again to enter to the third-level sub- page. a. When you choose the "Time" function, you can rotate the knob to adjust the hour setting, and then press the knob again to adjust the minute setting. After adjustment, press knob again, the clock icon on the LCD will flash momentarily to indicate the time has been set successfully. b. When you choose "Alarm" function, the operation is similar to the time setup. After finishing the alarm setup, press knob and hold for 2 seconds to return the third-level subpage for the on&off setting for the alarm. 6. How to set the system mute using one key control system i). Press the knob to enter the first-level sub-page (control panel). ii). Choose "Mute Control Menu", you can press knob to enter second-level sub-page (see the picture on Page 4). iii). Then press the knob again to set the system mute, it will turn off the unit's sound. Press knob and hold for 2 seconds to cancel the mute set. Installing battery in the remote control Since the remote control will be used for operations, you should begin by installing the supplied battery: 1. Turn the remote control over and pull out the battery compartment cover. 2. Insert the battery according to the polarity markings inside of the battery compart-ment. 3. Close the battery compartment cover. Notes about the remote control 1. If you find that the remote control can not be used at a normal distance from the main unit, the battery may be weak and need to be replaced. 2. Remove the battery if the remote control is not used for an extended period of time. 3. If battery is leaking, remove and dispose of it immediately. Avoid touching the leaked material and splashing it on to clothing, etc. Clean the battery compartment thoroughly before installing new battery. Trouble Shooting Problem Unit will not turn on. Display can't be turned on. Possible Reasons/Solutions ·The plug is not inserted properly; the socket has no power. ·"POWER" button has not been pressed. ·Incorrect selection of input signal. ·The leads are not connected correctly. ·Mute function is enabled. ·Sound source is not powered up. ·The speaker line is not connected properly. ·The signal plug is incorrectly connected or leads are short-circuited. ·Interference from strong exterior disturbance, turn off and then turn on again. ·Avoid direct sunlight/heat. No sound at all. Neither of the main channels have sound. Unit is operating abnormally .8.