Pyle PKBRTP100.5 Instruction Manual - Page 1
Pyle PKBRTP100.5 Manual
![]() |
View all Pyle PKBRTP100.5 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1 highlights
2. Insert white ow-control block into cross-bar, it would limit the beer ow and reduce over-foam. 2. Insert white ow-control block into cross-bar, it would limit the beer ow and reduce over-foam. by Homebrew Mini Keg System 3. Install faucet into spear body, make sure the connection is proper and tight. Remark: Improper connection would cause leakage of beer. PKBRTP50 PKBRTP100 UNIT OPERATION INSTRUCTIONS 4. Cut beer hose according to keg height and insert into spear, make sure hose can touch bottom of keg without overlong or over short. Remark: If beer hose is too short, beer would not be tapped completely. But if beer hose is too long, it may crimp inside the keg, because of incomplete tapping. 6. Turn in a new 16g C02 capsule with thread type of 3/8"-24 UNF, turn clockwise rmly into the regulator base. Important: DON'T stop turning if you hear a slight gas leak swish, nish turning it in all the way it seal properly. PART TWO: TAPPING 1. Attach the spear system to the keg. Make sure they are as tight as possible to avoid lessening or leakaging. 2. Connect the regulator to the spear system 1. Spear Body 8. Faucet Knob 2. Cross-bar 9. Regulator 3. Twist Tube 10. Regulator Base 4. Pressure Relieving Ring 11. Regulator Knob 5. Nut 12. Gauge 6. White Flow-control Block 13. 16g C02 Capsule 7. Faucet 14. Beer Hose PART ONE: SPEAR ASSEMBLY 1. Please clean mini-keg, cap, spear body, faucet and beer hose with warm water and mild soap before use. 5. Check whether the regulator knob is in OFF position. If not, please follow arrow mark instruction to turn the regulator knob counter clockwise to the OFF position. www.NutrichefKitchen.com www.NutrichefKitchen.com
![](/manual_guide/products/pyle-pkbrtp1005-instruction-manual-de1c821/1.png)