Pyle PKBRTP110 Instruction Manual - Page 2

O Ring Information

Page 2 highlights

5. Put a glass or pitcher under the faucet spout, with the faucet knob pulled forward (ON), slowly turn the regulator knob on in clockwise direction, until beer starts to ow out. Don't continue adding pressure, suggest tapping 5-8 PSI (Max pressure 30 PSI), so please stop turning the regulator knob when the pressure is enough to tap beer out with perfect foam. Too much pressure would cause over foam. When the beer stopped or ow slower, try turning the regulator knob on slowly, to get bigger pressure. 6. When you nish tapping, please turn regulator knob to OFF position. 7. If there is no beer owing out, then the CO2 capsule needs to be replaced, unless no beer is remained (Normally, 16g capsule can tap 4-5 liters of beer). Caution: Removing a punctured capsule from regulator should be done slowly. Swish is expected if pressure remains. 8. Turn the regulator knob o and install a new capsule into the regulator by following above steps. TROUBLE SHOOTING GUIDE 1. Faucet Leakage Solution: Screw out and remove the faucet, then install again, make sure the faucet can match the connection of spear tightly. 2. Too much Foam Solution: Decrease the pressure properly. 3. Leakage of CO2 CO2 capsule should be installed properly and tightly. In case there is CO2 leakage, please observe the position of leakage and continue with the tightening process, but never screw out if gas remains. PART FOUR: WARNING 1. Keep away from children under 18. 2. Never point cylinder towards someone's face. 3. Do not heat over140°F as rupture may occur! 4. Discontinue using of this equipment if unsolvable leakage or visible damage is found. 5. Capsule end become punctured when turned into regulator base. Unscrewing before it's empty can result in loss of high pressure gas. Please remember, never unscrew the CO2 capsule before gas used up, liquid CO2 spray onto unprotected skin may cause freezing burns. 6. Exterior of capsule may become frozen when in use, this is normal. But don't touch with bare hands, your ngers could stick to the frozen surface and cause frostbite. 7. Please ship via land or sea shipment, never bring CO2 capsule when you travel by air. O RING INFORMATION: E D A C B A 35 x 3.1 MM (1pcs) B 13 x 10 x 2 MM (1pcs) C 8 x 1.5 MM. (1pcs) D 11 x 1.5 MM (2pcs) E 8 x 2.5 MM (3pcs)ɹ (Out Diamter * Thickness) O RING ASSEMBLY: Questions? Issues? We are here to help! Phone: (1) 718-535-1800 Email: [email protected] This product can expose you to a chemical or group of chemicals, which may include "Chromium" which is known in the state of California to cause cancer, birth defects, or other reproductive harm. For more info, go to https://www.p65warnings.ca.gov/. www.NutriChefKitchen.com

  • 1
  • 2

www.NutriChefKitchen.com
5. Put a glass or pitcher under the faucet spout, with the
faucet knob pulled forward (ON), slowly turn the
regulator knob on in clockwise direction, until beer
starts to flow out.
Don’t continue adding pressure, suggest tapping 5-8
PSI (Max pressure 30 PSI), so please stop turning the
regulator knob when the pressure is enough to tap
beer out with perfect foam. Too much pressure would
cause over foam. When the beer stopped or flow slower,
try turning the regulator knob on slowly, to get bigger
pressure.
6. When you finish tapping, please turn regulator knob to
OFF position.
7. If there is no beer flowing out, then the CO2 capsule
needs to be replaced, unless no beer is remained
(Normally, 16g capsule can tap 4-5 liters of beer).
Caution:
Removing a punctured capsule from regulator
should be done slowly. Swish is expected if pressure
remains.
8. Turn the regulator knob off and install a new capsule
into the regulator by following above steps.
TROUBLE SHOOTING GUIDE
1. Faucet Leakage
Solution:
Screw out and remove the faucet, then
install again, make sure the faucet can match the
connection of spear tightly.
A
35 x 3.1 MM (1pcs)
B
13 x 10 x 2 MM (1pcs)
C
8 x 1.5 MM. (1pcs)
D
11 x 1.5 MM (2pcs)
E
8 x 2.5 MM (3pcs)
(Out Diamter * Thickness)
O RING ASSEMBLY:
2. Too much Foam
Solution:
Decrease the pressure properly.
3. Leakage of
CO2
CO2 capsule should be installed properly and tightly.
In case there is CO2 leakage, please observe the position
of leakage and continue with the tightening process, but
never screw out if gas remains.
PART FOUR:
WARNING
1. Keep away from children under 18.
2. Never point cylinder towards someone’s face.
3. Do not heat over140°F as rupture may occur!
4. Discontinue using of this equipment if unsolvable
leakage or visible damage is found.
5. Capsule end become punctured when turned into
regulator base. Unscrewing before it’s empty can result
in loss of high pressure gas. Please remember, never
unscrew
the CO2 capsule before gas used up, liquid
CO2 spray onto unprotected skin may cause freezing
burns.
6. Exterior of capsule may become frozen when in use,
this is normal. But don’t touch with bare hands, your
fingers could stick to the frozen surface and cause
frostbite.
7. Please ship via land or sea shipment, never bring CO2
capsule when you travel by air.
O RING INFORMATION:
A
B
C
D
E
Questions? Issues?
We are here to help!
Phone:
(1) 718-535-1800
Email:
This product can expose you to a chemical or group of chemicals, which
may include
”Chromium”
which is known in the state of California to cause
cancer, birth defects, or other reproductive harm. For more info, go to
.