Pyle PL78DLB PL78DLB Manual 1 - Page 6
Speaker Setup, 16.6 Digital Setup, Op Mode, Dynamic Range, Dual Mono - speakers
View all Pyle PL78DLB manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
1.5 Wires Connection Description The Description of the Wires Connection Fixing Screw Bolt Wiring Connecting Socket 1 4.16.5 SPEAKER SETUP Wiring Connecting Socket 2 PARKING LINE BROWN PINK REVERSAL LINE Black Radio Antenna jack Black Note: 1. Use the clip end of a Ground Line provided by manufacturer to connect the Fixing Screw Bolt, use another end of t he Ground Line to connect the negative pole of the power source. Otherwise, the video on screen maybe flashes. 2. When turning on rear view camera, sound of the current function mode will be muted. The Description of the Wires Connection of the Wiring Connecting Socket 1 WIRING CONNECTING SOCKET 1 WIRING CONNECTING PLUG 1 YELLOW MEMORY B+ 10 A FUSES BLACK(GND) RED IGNITION SWITCH 0.5 A FUSES BLUE AUTO ANT SUBWOOFER LINE OUT RCA LINE OUT YELLOW RED R WHITE L FRONT WHITE GRAY FRONT LEFT SP WHITE / BLACK GREEN GRAY / BLACK VIOLET RIGHT SP REAR GREEN / BLACK VIOLET / BLACK REAR NOTES: 1. Only speakers with 4 ohms impedance may be used. 2. Ensure that the blue auto antenna cable does not make contact with any ground connection. The Description of the Wires Connection of the Wiring Connecting Socket 2 WIRING CONNECTING SOCKET 2 RED R WHITE L YELLOW VIDEO BROWN AUX IN WIRING CONNECTING PLUG 2 YELLOW GREY YELLOW YELLOW VIDEO OUT LINES BLACK REAR VIEW CAMERA NOTES: The rear AUX IN and the front AUX IN can not be used at the same time. Description of Connecting the Parking Brake Line to the Parking Brake System Built in the Car Parking brake Ground(-)/Park Break(Green) Parking brake switch (inside the car) To metallic body or chassis of the car NOTE: after connecting the Parking Line, the video on the small monitor of the front panel will be display only after braking the car. DOWNMIX It is for selecting your desired sound effect when there is no center speaker and subwoofer. There are 3 modes: LT/RT, STEREO, VSS. LT/RT: When playing a media with PRO LOGIC Dolby stereo effect, choose the item, so it will output audio signal with vivid theatre effect. STEREO: If you choose the item, when outputting audio signal with 5.1 channels, it will output the left and right channels of signal ; when outputting audio signal with 2 channels, it will output the common 2 channels of stereo signal. VSS: If you choose the item, when playing a media recorded with 5.1 channels, the main channel speakers can output audio signal with VSS effect. 4.16.6 DIGITAL SETUP OP MODE It is for selecting audio output mode DYNAMIC RANGE After selecting the compression mode of LINE OUT, set the item, so you can adjust the linear compression ratio. If you set it to be FULL, the Peak-to-Peak value of the audio signal is the minimum; if you set it to be OFF, the Peak-toPeak value is the maximum. DUAL MONO It is for selecting a desired audio output mode for the left and right ways of signal. It is mainly for Karaoke of Ac3. There are 4 modes in all as follows: STEREO, MONO L, MONO R, MIX MONO. PDF created with FinePrint pdfFactory trial version http://www.pdffactory.com