Pyle PLA1200 PLA2260 Manual 1 - Page 10

features and specifications 4 ch amp PLA-4120 crossover mode selector When used with normal, full range system, set this switch to "FULL" . output power @ 14.4v DC, 1KHz PLA-4120 input level controls crossover frequency control If you wish to use the internal crossover to power a driver or specific frequency range, use the "LPF"or "HPF" FOR the "LOWPASS" OR HIGHPASS" settings. Enables the matching of input levels to the output levels from head unit (or other signal source). The input sensitivity of adjustment ranges from 6V to 200mV. When crossover mode selector is in HIGHPASS mode, this control sets RMS Power @ 4 Ohms THD @ 4 Ohms RMS Power @ 2 Ohms THD @ 2 Ohms Maximum Power Output bridged Power at 4 Output 35Watts x 4 00 Watts x 4 00 Watts x 4 00 Watts x 4 250 Watts x 4 500 Watts x 2 the lower frequency limit for audio program sent to the speakers. When crossover mode selector is in LOWPASS mode, this control sets frequency response 15 Hz-30 KHz the upper frequency limit for audio program sent to the speakers. input impedance The crossover is continuously variable adjustment from 40 t0 250 Hz. bass boost level selector This selector switch permits the bass level an increase of 18dB. bass boost level control This control permits adjustment of the bass level up to an increase of low level inputs input sensitivity 10K Ohms 8 approximately up to 18dB. low level inputs 250mV sub sonic control When the sub sonic selector switch is in "ON" mode, this filter control permits continuously variable adjustment from 10 to 100Hz. S/N ration channel separation >95dB >65dB low level input This amp features gold-plated RCA type jacks for high impedance input. Use these with car stereo output which uses RCA type connector cables. crossover filters low Pass high Pass 40 Hz-250 Hz 40 Hz-250 Hz high level input If your car stereo jacks RCA type output, use this adaptor to connect the bass boost 0~ +18dB AUX line outputs high-low level input adaptor to connect the speaker output leads of car stereo and the RCA input jacks of amp. This amp features gold-plated RCA jacks for AUX line outputs. Use these outputs. Use these for unlimited system expansion to the next CHOPPER. matching speaker impedance stereo mode bridged mode 2-4 Ohms 4-8 Ohms power LED This indicator is illuminated in GREEN when power is applied. maximum current draw 20Ax2 protection LED power fuse power terminals This indicator is illuminated in RED when the built-in protection circuitry is actirated. The fuse protects the amplifier and your car's electrical system from short circuit conditions. Use these connectors to deliver power, ground, and remote turn-on control power supply voltage dimensions (W x H x L) mm inches 14.4V DC Neg. Ground (10.5-16V) 270 x 36 x 330 10.63 x 1.42 x 13 to the amplifier. speaker connectors These terminals are 14K gold plated to guarantee high conductivity and minimum signal loss.